![]() ![]() Hope this helps to put your mine at ease. My HDD light goes off when I come out of Standby mode but is always on otherwise. This will not hurt the drive or the system in any way." Right-click the drive that you want to check, and then click Properties. The system is in a sleep state, hibernation, or is turned off. For example, you can check your computer's primary hard disk to fix some performance issues, or you can check an external hard drive if it's not working properly. The system is running on battery, and the battery has more than 5 charge. This is the result of the laptop not being fully ATA compliant in accordance with the power specifications. You can solve some computer problems by checking a drive or drives for errors. This is NOT a problem caused by the drive. 2 (more likely)- There is a process/application running in the background and you need to determine what it is. As for the drive LED it does light up, it just stays lighted and doesnt flash like. If your hard drive light is solid, that is usually an indication of 1 or 2 things: 1 (unlikely)- The wires for the HDD light on the system board are not properly connected thus leaving the light on all the time. Status LEDs are all ON, as they should be. We see that it blinks together with the other disks when there is a read/write activity, but it gets back to it's ON state (instead OFF, like the others). However, there is one issue: its activity LED is always lit. ![]() ![]() When its a black screen I cannot get into BIOS, and my AsRock BIOS is at 1.90 which is the newest version. The array has been rebuilt and is in its optimal state. In your case the system doesn’t seem to be able to properly detect the correct voltage of the mobile drive, that is why it causing the drive activity light to stay on constantly. It may be a problem with BIOS which is not related to the hard drive, and the drive LED does not light up because the boot up sequence never gets that far. On the 6027R-CDNRT+, this LED indicates hard drive activity when flashing. Systems should be able to properly detect the lower 3.3 volts according to the ATA specification. Indicates network activity on the LAN2 port when flashing. Since the PC is brand new I would hesitate to kill the light (an integral part of motherboard back panel) irreversibly the hard way. "The newest Mobile drives are moving to using 3.3 volts on the interface lines (from 5 volts on previous models) to reduce power consumption. The activity light turns on when the computer reads from or writes to the hard drive. O2 - BHO: NAV Helper - (WUWebControl Class). ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |